Setting The Tuning Step (Ts) Frequency; Enabling The Receive Preamplifier - XIEGU G106 Operation Manual

Setting the Tuning Step (TS) frequency.

To select the step required when tuning (100Hz, 1 KHz etc) we use the BAND
buttons as follows:
Long-press the BAND left or right button for 2s to step up or down in the
displayed step value.
Once set, turn the main tuning knob to go to the required frequency.
E .
NABLING THE RECEIVE PREAMPLIFIER
To turn on or off the pre-amplifier long-press the MODE button. When
enabled a P will be displayed at the top of the display.
Note: The pre-amplifier is rarely required on the lower HF bands and it is
recommended to turn it off on the higher bands if there are very strong
signals or interference present.
Page 14