Setting Operation Frequency - XIEGU G90 Operation Manual

Set the operating frequency
There are three ways to set the G90 operating frequency. You can use
the large main tuning knob, the multi-function knob and the
microphone.
1. Set the tuning steps using the main knob

Short press the main knob, select 100Hz, 1kHz, 10kHz steps.

Rotate the main knob to set the frequency of the current
step.
2. Rotate the Multi-function knob – 100khz increments
3. Set the frequency manually using the microphone:
 Press the [F-INP ENT] button on the microphone. The G90 enters the frequency setting state. The cursor will blink in the
first position on the left side of the frequency display.
 Enter the frequency values you want to set, and then press the [F-INP ENT] button again to complete the frequency setting.
For example, set the current frequency to 14.09000MHz, and the key order is as follows:
First press the [F-INP ENT] button;
1.
Press the 1 4 . 0 9 0 0 0 number key in sequence;
2.
Press the [F-INP ENT] button again, complete the setup.
3.
LCD Display
Main Knob
20