Charging And Maintenance Of Build-In Battery - XIEGU X5105 Operation Manual

Hf/50mhz portable short-wave transceiver

Instruction manual (31 pages)

Operation manual (23 pages)

Manual (21 pages)

Table of Contents

X5105 has a built-in 3800mAh polymer lithium battery pack. When there is no external power supply connected, the battery pack

will supply power for the whole device. When external power supply is provided, the built-in circuit will be automatically switched to the

external power supply.

Charging method:

1. Enter system menu #9:Charger;

2. Rotate large knob and select 'ON', and then enable charging

function;

3. Select 'OFF' to disable charging function when operating.

4. Set voltage of external power supply between 13.5V~15.0V

and connect to the power supply port of external power source,

and then the main machine will be automatically charged.

Note: X5105 will be automatically charged and T/R indicator

light will be red when charging function is enabled and

connected with appropriate external power supply under

shutdown state. T/R indicator light will be green when

charging is finished.

5. The maximum charging time is 10-12h. Charging will be

automatically stopped when battery is fully charged, and the

screen will display charging finishing information as shown in

right figure.

Voltage of battery is generally between 12.1~12.5V after

charging.