Installing Angle Adjustable Footplate; Adjusting The Legrest Angle; Adjusting The Footplate Height - Invacare Action 4 NG Heavy Duty Service Manual

Installing Angle Adjustable Footplate

NOTE: For this procedure, refer to FIGURE 2.4.
NOTE: This procedure is for individual Angle and Depth Adjustable Footrests standard
version (1) and new version (2) only.
1. Position the angle adjustable footplate on the footrest support tube at the desired
height.
2. Using the locking screw, loosely secure the angle adjustable footplate to the
footrest support tube.
NOTE: Refer to Adjusting Footrest Height paragraph on page 9.
3. Using the mounting screw, adjust to the desired angle by rotating the footplate and
depth by sliding the footplate into the tooth plates support.
4. Using the mounting screw
Adjustable Footplate to the footrest tube. Securely tighten.
5. If necessary, repeat STEPS 1
Adjusting Elevating Legrest Angle, Height and Calf
pad Height/Depth
NOTE: For this procedure, refer to FIGURE 2.5.

Adjusting the Legrest Angle

1. Loosen locking knob
2. Adjust to desired angle, securely engage the locking knob
3. If necessary, repeat STEPS 1

Adjusting the Footplate Height

1. Loosen locking screw
G
version (1) or
4 to adjust remaining Angle Adjustable Footplate.
-
FIG URE 2.4 Installing Angle Adjustable Footplate
D
securing the rotating axle of the elevating legrest.
2 to adjust remaining elevating legrest angle.
-
B
securing the slide tube to the elevating legrest.
SECTION 2—FRONT HANGERS
H
version (2), secure the Angle
F.
9