5.5 Adjustment Possibilities for Nucleus Midline
Holder
WARNING!
Risk of Injury or Death
Loose small parts can lead to choking hazard that
may result in injury or death.
– Do not remove any small parts except to
replace the joystick knob.
– Do not leave removed joystick knob unattended.
– Closely supervise children, pets or people with
physical/mental disabilities.
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod, can
lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.
5.5.1 Adjusting Depth of Midline Holder
1529686-AA
1. Loosen lever A.
2. Shift midline holder to desired position.
3. Tighten lever.
5.5.2 Adjusting Height of Nucleus Midline Holder
You can adjust the height of the nucleus midline holder in
two ways:
•
Adjust it together with the armrest height. Refer to
corresponding armrest chapters.
•
Adjust the height of the nucleus midline holder only.
Refer to section below.
•
3/16 inch Allen key
1. Loosen screw A.
2. Adjust nucleus to desired height.
3. Tighten screw.
5.5.3 Adjusting Joystick/Display Position on Nucleus
Midline Holder
DLX-REM110, DLX-REM2XX, DLX-REM400
•
4 mm Allen key
•
8 mm wrench
Tilting Remote
Fig. 5-8
Setup
41