Table of Contents
Advertisement
Other Settings
1. Setting an ID Name
An ID name is a name that can be assigned to each memory channel by entering it directly using keys.
When measurement is performed, the ID name is displayed together with the memory channel no. and probe no. in
the LCD display section.
• Number of characters you can enter ................. Up to 10 characters
• Type of characters you can enter ....................... "1" to "9", "." (comma), "A" to "Z", "—", " " (space)
For instance, if you set "EXT D-1.50" for CH01, the LCD display section
will look like the one shown on the right.
This function is useful when you want to specify that user calibration and
target color have been set for what type of display with what colors.
[Operating Procedure]
1
.
Press the MEMORY CH
memory channel to which you want to set an ID name
appears.
2
.
Press the
The LCD display section will switch to the menu selection screen.
3
.
Press the
Each time the
PROBE → SYNC → ID Name input → RANGE → Measurement
Speed → Number of Digits → RS232C Baud Rate → PROBE.
4
.
Enter the desired ID name.
Ten-key (
to
key ................................................ The
key ................................................ Moves the cursor to the right each time this key is pressed.
and
key.
key to open the ID name input screen.
key is pressed, the screen will switch in the order
,
) .................... Used to enter values. (The cursor moves to the right each time a
value is entered.)
alphabet, hyphen (-) and space. Pressing this key again will restore
the original function of the ten-key.
keys until the
to
and
keys on the key panel can be used to enter an
66
Memory channel
H01 EXT Ad P1
[EXT D-1.50]
Memory channel
H01 EXT Ad P1
[
]
MENU : SELE T
PUSH SPA E KEY
H01 EXT Ad P1
[
]
_
Probe no.
ID name
Advertisement
Table of Contents
