Table of Contents
Advertisement
1. Setting/Changing the Target Color by Measurement
[Operating Procedure]
When the optional 4-Probe Expansion Board CA-B04 is used
Select the probe no. to which you want to set the target color. The target color can be set independently for each
probe connector ([P1] to [P5]) for each memory channel.
1
Press the
The LCD display section will switch to the menu selec-
tion screen.
2
Press the
tion screen.
Each time the
in the order PROBE → SYNC → ID Name input →
RANGE → Measurement Speed → Number of Digits →
RS232C Baud Rate → PROBE.
3
Press the
you want to select.
Each time the
4
Press the
* By default (factory setting), the instrument is set so that [P1] will be selected automatically when the POWER switch is set to ON. If you
want to change this setting, refer to page 30.
1
.
Press the MEMORY CH
channel where you want to set the target color appears.
2
.
Place the measuring probe with the display and take mea-
surement.
3
.
While the probe is placed with the display, press
the HOLD key.
The latest measured values will be hold and the HOLD LED
lights up.
4
.
Press the
The measured color of the display will be set as the target color.
5
.
Press the HOLD key to start measurement.
The HOLD LED will go out.
* To view the target color you set, press the MR key.
(For details, refer to page 72.)
* By default (factory setting), x=0.3127, y=0.3293 and Lv=40.00 (cd/cm
for each memory channel.
3,5
1
HOLD LED
key.
key to open the PROBE selec-
key is pressed, the screen will switch
key to display the probe no.
key is pressed, the probe no. switches in the order [P1] ... .
key to confirm the selection.
and
key.
4
2
Menu selection screen
ENU : SELECT
PUSH SPACE KEY
PROBE selection screen
SELECT : PROBE
P1 35881112
SELECT : PROBE
P3 35881113
Probe no.
keys until the memory
2
) are set
62
Press the
key
until the desired
probe no. appears.
Memory channel
H01 EXT Ad P1
[
]
Advertisement
Table of Contents
