Table of Contents
Advertisement
Manual Structure
This manual is divided into sections as shown below according to the contents.
This section explains how to install the instrument, connect AC power, turn ON/OFF the power, and
input the vertical synchronizing signal.
About Installation
Provides operating environmental conditions for the instrument and notes on installation.
About Connection
Explains how to connect measuring probes and connect the power cord.
(Also explains installation method for the optional accessory "4-Probe Expansion Board".)
* Before turning on the power: Refer to pages 84 to 86 if you are going to communicate the instru-
ment with the PC via RS-232C or USB.
Turning the Power ON/OFF
Explains how to turn ON/OFF the power.
● The Preparation/Setting/Measurement section explains the procedure up to measurement.
The Measurement Preparation section explains preparations (instrument setting, zero calibration) that
are required prior to measurement.
Zero Calibration
Explains the zero point adjustment method.
(Measurement cannot be performed if zero calibration is not completed.)
Selecting, Masurement Speed, SYNC Mode, Display Mode and the Number of Display Digits
Explains how to select SYNC mode, that selects measurement time according to the display's vertical scanning frequency,
as well as explaining how to select measurement mode and the number of display digits.
To the Setting section P. 45-74
When the optional 4-Probe Expansion Board CA-B04 is used
Selecting Probe No.
Explains how to select the measuring probe whose measured value is to be displayed.
* Go to the Measurement section if you are going to perform measurement using
Konica Minolta's calibration standard and are not going to use analog display.
6
Page 25
Page 26
Page 29
Page 34
Page 36
Page 43
Advertisement
Table of Contents
