Table of Contents
Advertisement
5
REMOTE key ....................................... • Sets the instrument in remote mode (i.e. communication with the
6 MEMORY CH
<Keys on Key Panel>
1
Number-key (
~
2
ALPHA key (
) ................................... • Used to enter alphabets. This key enables you to use the number-
3
Alphabet keys (
4
MENU key (
) ..................................... • Switches the LCD display section to the menu selection screen.
5
CAL key (
) ........................................ Normal Screen
• Pressing this key while the REMOTE key is lit will cancel remote
key ........................ • Used to select a memory channel (CH00 to 99).
key
,
) .................. • Used to enter calibration data for user calibration (page 50), target
~
,
) ................ • Used to enter alphabets for the ID name.
• When CH00 is selected as the memory channel
• When thememory channel other than CH00 is selected as the memory
• When an analyzer measurement mode is selected
Menu Selection Screen
• Pressing the
PC is possible via RS-232C or USB).
(The REMOTE LED will light up. See page 86.)
mode. (The REMOTE LED will go out.)
(Note) Remote mode should not be activated unless you are going to communi-
cate with the PC.
Otherwise, the other keys will be inoperative.
Pressing the
key will switch memory channel in the order
"00→01→02 ...
98→99→00 ... ".
Pressing the
key will switch memory channel in the order
"00→99→98 ...
01→00→99 ... ".
The memory channel switches from one to another each time the
key is pressed, and switches continuously if the key is left held
down.
color (page 61), ID name (page 66) and analog display range (page
68).
key as alphabet keys. Pressing this key again will restore the origi-
nal function of the ten-key.
Pressing this key again will restore the original function of the LCD
display section.
You can enter a value for the target color. (Page 64)
channel
You can set CA-100 for input of WRGBdata for user calibration.
(Page 50)
You can set CA-100 for input of RGB emission characteristic and
target color (W). (Page 58)
key in the menu selection screen causes the screen
to switch as follows.
PROBE selection → SYNC selection → ID Name input → RANGE
setting → Measurement Speed selection → Number of Digits set-
ting → RS232C Baud Rate selection → PROBE selection
17
Advertisement
Table of Contents
