Table of Contents
Advertisement
In this example, "EXT D-1.50" is set as the ID name.
1 Press the
key.
2 Press the
key twice.
"E" will appear at the cursor position.
3 Press the
key twice.
"X" will appear at the cursor position.
4 Press the
key once.
"T" will appear at the cursor position.
5 Press the
key twice.
" " will appear at the cursor position.
6 Press the
key once.
"D" will appear at the cursor position.
7 Press the
key once.
"-" will appear at the cursor position.
8 Press the
key.
9 Press the
key.
"1" will appear at the cursor position.
10 Press the
,
".", "5" and then "0" will appear at the cursor position.
5
.
Press the
key.
The ID name will be set for the selected memory channel.
* To cancel ID name setting, press the
<Notes when Setting an ID Name>
● The ID name will be kept even if the POWER switch is set to OFF.
● Never press the following keys during ID name setting.
Doing so will cancel setting and activate the mode corresponding to the pressed key.
( 0-CAL , MODE , REMOTE , MR , MEMORY CH
If the
key is pressed while the
for setting the analog display range will appear.
●
When the optional 4-Probe Expansion Board CA-B04 is used
Only one ID name can be set for each memory channel irrespective of the number of probes. (The specified ID
name will be common to all probes [P1] to [P5].)
and then
key.
key.
key is not held down (i.e. the ten-key is not used as alphabet key), a screen
,
)
67
H01 EXT Ad P1
[E
]
_
H01 EXT Ad P1
[EX
]
_
H01 EXT Ad P1
[EXT
]
_
H01 EXT Ad P1
[EXT
]
_
H01 EXT Ad P1
[EXT D
]
_
H01 EXT Ad P1
[EXT D-
]
_
H01 EXT Ad P1
[EXT D-1
]
_
H01 EXT Ad P1
[EXT D-1.50]
_
Advertisement
Table of Contents
