PROLEC PME200 User Manual page 40

8.3.3 Min Radius Limit Setting - using Current nearest Point
Move equipment to required min
radius limit and press this button
To set the min radius limit using
the machine, move the equip-
ment to the desired minimum ra-
dius, and press the 'current near-
est point' button. A confirmation
box will appear reporting the ra-
dius set. Press the TICK button
to continue.
that the current limit activates at the set point. The restriction cannot be de-
activated if in the alarm state. Observe the operational limitations given in
section 4.
562200-000, Issue 1.2, December 2015
Set the limit using the nearest point of the machine.
Ensure the equipment is off the ground before set-
ting the limit.
Once a limit is set, the internal alarm will sound and the RED LED
will light if the equipment exceeds the current limit. Always check
40 of 62