Stability Control Overload - PROLEC PME200 User Manual

7.5 Stability Control Overload

Where an overload condition occurs the machine hydraulics will be locked to pre-
vent any further dangerous movements. Only those movements that allow safer
operation remain active. The radius cannot be increased and the load cannot be
raised. The internal and external alarms will sound in conjunction with visual indi-
cators on the display.
7.5.1 Hydraulic Limitation Control
The system will cut motion to the appropriate articulation in a hydraulic limit state and in-
dicate this via internal and external alarms in conjunction with visual indicators on the dis-
play.
Where an overload condition occurs the machine
hydraulics will be locked to prevent any further
dangerous movements. Only those movements
that allow safer operation remain active. The ra-
dius cannot be increased and the load cannot be
raised.
After three seconds a soft override will become available, see section 7.6.1
In the event of an approach to overload or an overload condition, the lifting
point should only be moved in a direction that increases the safe working
562200-000, Issue 1.2, December 2015
load. See section 4 for further information.
If the load is greater than 105% of the
maximum safe working load
The load capacity indicator will be red

The red LED will flash

The internal and external alarm will

sound
The message shown here will be

displayed
Motion control of the machine will

operate, motion cut is indicated by
RED arrows, safe motion is indicated
by GREEN arrows
20 of 62