Troubleshooting Guide; Section 8 Troubleshooting Guide - Taylor 152 Operator's Manual

Section 8
PROBLEM
1. No product being
dispensed.
2. The machine will not
operate in the "AUTO"
mode.
3. The product is too stiff.
Models 150, 152, 162, 168

Troubleshooting Guide

PROBABLE CAUSE
a. The power switch is in the
"OFF" position.
b. The mix level is
inadequate in the mix
hopper.
c. The beater motor
overloaded.
d. The unit is unplugged at
the wall receptacle.
e. The circuit breaker is
tripped or the fuse is
blown.
f. The freezer door is
incorrectly assembled.
g. Product is being drawn off
in excess of the freezer's
capacity.
a. The unit is unplugged.
b. The refrigeration system is
not activated.
c. The circuit breaker is
tripped, or the fuse is
blown.
d. The beater motor
overloaded, causing a loss
of power to the power
switch.
a. The temperature control
or the T.Q.C. is set too
cold.
29
REMEDY
a. Place the power switch in
the "AUTO" position.
b. Fill the mix hopper with
mix.
c. Reset the freezer.
d. Plug in the power cord.
Press the reset button.
e. Place the circuit breaker in
the "ON" position, or
replace the fuse. Press
the reset button.
f. See "Operating
Procedures" for proper
installation.
g. Stop drawing product and
allow the unit to recover.
a. Plug in the power cord;
press the reset button.
b. On T.Q.C. units,
momentarily raise the
draw switch to activate the
refrigeration system.
c. Place the circuit breaker in
the "ON" position, or
replace the fuse. Press
the reset button.
d. Reset the freezer.
a. Adjust the temperature
control. Do not set the
temperature colder than
18_F (- 8_C). If T.Q.C.,
contact service technician.
Troubleshooting Guide
PAGE
REF.
24
23
16
16
16
19
- - -
16
24
16
16
16