Taylor 152 Operator's Manual page 24

Step 7
Finger- tighten the handscrews, making sure they are
tightened equally and that the door is snug. Do not
over- tighten the handscrews.
IMPORTANT! Handscrew and door damage can
result if the handscrews are over- tightened or if
one handscrew is tightened more than the other.
Step 8
Slide the two o- rings into the grooves on the draw
valve(s) and lubricate with Taylor Lube.
Figure 19
Note: For the Models 162/168, install the valve seal
in the grooves on the center draw valve and lubricate
with Taylor Lube. This special seal will prevent mix
from one freezing cylinder from traveling into the
second cylinder.
Figure 20
150105
Operating Procedures
Step 9
Lubricate the inside of the freezer door spout(s) from
the bottom. Insert the draw valve(s) into the freezer
door from the bottom.
Note: The draw valve is installed correctly when the
slotted opening in the draw valve is visible through the
"window" of the freezer door.
Step 10
Slide the o- ring into the groove on the draw valve
handle and lubricate with Taylor Lube.
20
Figure 21
Figure 22
Figure 23
Models 150, 152, 162, 168