JAI GO-5100MP-PGE User Manual page 53

Item
m） JAI Custom Control Shading
Shading Correction Mode
Shading Mode
Perform Shading Calibration
Shading Detect Result
Item
n） Counter And Timer Control
Counter 0 to 2
Counter 0 to 2 Event Source
Counter 0 to 2 Event Activation Rising Edge
Counter 0 to 2 Reset
Counter 0 to 2 Refresh
Counter 0 to 2 Value
Counter 0 to 2 Status
Item
o） JAICustomControlPolarized
Polarize Image Selector
Item
p） JAICustomControlMisc
VideoProcessBypassMode
Trigger Option
OptIn Filter Selector
Video Send Mode
Setting range Default value
Flat Shading Flat Shading
Off, User1, User2, Off
User3
ー ー
ー ー
Setting range Default value
Counter 0 to 2 ー
Off, Off
Frame Trigger,
Frame Start,
Exposure Start,
Frame Transfer End
ー
Falling Edge
ー ー
ー ー
ー 0
ー Counter Active
Setting range Default value
Raw Image, Raw Image
Polarize Angle And Degree
Setting range Default value
Off, On Off
Off Off
10μs, 100μs, 500μs, 10μs
1ms, 5ms, 10ms
Normal Mode Normal Mode
— 53 —
Description
Configure shading correction settings.
Select the shading correction method.
Set the area to which to save shading
correction data.
When this is set to [Off], shading correction
data is not saved.
Execute shading correction.
Display the shading correction results.
Description
Configure counter settings.
(This camera only supports counter functions.)
Select the counter.
Assign the counter event signal for which
you want to read the count value to a
dedicated counter, and read the value.
Set the count timing.
Reset the counter.
Update the count value.
Display the count value.
Display the counter status.
Description
Configure controling polarization settings.
Set the video output mode
Description
Configure settings for other JAI functions.
Enable/disable VideoProcessBypass mode.
Select the surge protection filter
Display the [VideoSendMode].
GO-5100MP-PGE