JAI GO-5100MP-PGE User Manual page 13

Note
The following formula can be used to estimate the focal length.
Focal length ＝ WD /（1 ＋ W/w）
WD ：Working distance （distance between lens and object）
W ：Width of object
w ：Width of sensor（8.5 mm on this camera）
② Direct connection（or MP-43 tripod adapter plate）
When mounting the camera directly to a wall or other device, use screws that match the
camera locking screw holes on the camera (M3, depth: 3 mm). Use the supplied screws to
attach the tripod adapter plate.
Caution
For heavy lenses, be sure to support the lens itself. Do not use configurations in which its weight
is supported by the camera.
③ LAN cable
Connect a LAN cable to the RJ-45 connector.
• Use a LAN cable that is Category 5e or higher (Category 6 recommended).
• When supplying power via PoE, connect to a PoE-compatible switching hub or a PoE-compatible
network card.
•Refer to the specifications of the cable for details on its bend radius.
Caution
Secure the locking screws on the connector
manually, and do not use a driver. Do not secure
the screws too tightly. Doing so may wear down the
screw threads on the camera. (Tightening torque:
0.147 Nm or less)
④ Network card
Install this in the computer that will be used to configure and operate the camera. As the
GO-5100MP-PGE supports PoE, you can also use PoE-compatible network cards. Refer to
the instruction manual of the network card, and configure settings on the computer as
necessary.
⑤ Computer
Use a computer that meets the following requirements.
Operating system (OS):
Microsoft Windows 7/8/10 32-bit/64-bit edition
CPU: Intel Core i3 or higher
Memory:
Windows 7/8/10 32-bit edition: DDR3, 4 GB or higher
Windows 7/8/10 64-bit edition: DDR3, 8 GB or higher
Graphics card: PCI-Express 3.0 or higher
Network card: We recommend using a network card that uses an Intel chip.
— 13 —
GO-5100MP-PGE
Secure manually.
Do not secure too tightly.