Installing The Pedal Sensor; Connecting The Connector - JUKI DDL-7000A-7 Series Instruction Manual

2. Installing the pedal sensor

❶

3. Connecting the connector

WARNING :
• To protect against personal injury resulting from abrupt start of the sewing machine, be sure to turn
the power OFF, unplug the machine and wait for five minutes or more before installing the pedal
sensor.
• To prevent damage of device caused by maloperation and wrong specifications, be sure to connect
all the corresponding connectors to the specified places. (If any of the connectors is inserted into a
wrong connector, not only the device corresponding to the connector can break but also it can start
abruptly, inviting the risk of personal injury.)
• To prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• Do not connect the power plug until the connection of cords is completed.
• Fix the cords while taking care not to forcibly bend them or excessively clamp them with staples.
• As for the details of handling respective devices, read carefully the Instruction Manuals supplied
with the devices before handling the devices.
Connector
connection diagram
Auto-lifter
Solenoid &
LED/TB unit
For upgrading
Pedal
Underside of the table
Pedal sensor
Pedal sensor cable
❶
AC cable
Staples
1) Install the pedal sensor to the table with mounting
screws ❶ supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicular
to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
Do not insert the power plug into the
wall outlet.
Check to be sure that the power switch
is turned OFF.
1) Connect pedal sensor cable ❶ supplied with the
unit to the control box.
Refer to the connector connection diagram for
connecting ports of the cables.
Be sure to fully insert the connectors
into the corresponding ports until they
are locked.
2) Fix the pedal cable and AC input cable
with a staple.
– 3 –