JUKI DDL-7000A-7 Series Instruction Manual page 25

(3) Constant-dimension stitching pattern
The constant-dimension stitching pattern can be set.
[How to set the constant-dimension stitching]
* Straight stitching
L

Z
❻ - 

 to enable the constant-dimension
1) Press
sewing pattern (straight stitch).
When the constant-dimension sewing pattern is
enabled, is displayed on the display portion L.
Immediately after the constant-dimension stitching
is enabled, the numbers of reverse feed stitching
processes (A, B, C and D) are displayed on the
display section Z.
❸ is pressed, the content shown on
2) When
display section Z is changed over to the number
of stitches for the constant-dimension stitching.
The number of stitches (0 to 999) for the con-
stant-dimension stitching can be selected by
pressing
– 23 –
❻～ .