Installing The Electrical Box; Preparing For Installation Of The Control Box; Installing The Pedal Sensor - JUKI LU-2828V-7 Instruction Manual

2-8. Installing the electrical box

2-8-1. Preparing for installation of the control box

Secure toothed washer ❷ and vibration-proof rubber ❸ to control box ❶ . (At four locations)
1)
* Tighten the toothed washer until it protrudes the control box surface by 0.8 mm.
Secure control box mounting plate ❹ to the control box with plain washers ❺ and nuts ❻ . (At four loca-
2)
tions)
* Secure the mounting plate by fitting the screws against the U-groove in the mounting plate.
2-8-2. Installing the electrical box
❷
a
❶

2-9. Installing the pedal sensor

❶
❷
a
❷
❶
0.8 mm
Install electrical box ❶ to the table by fixing four ac-
cessory bolts ❷ , which are supplied with the electri-
cal box, in holes a in the table.
Secure pedal sensor ❶ to the table with two plain
washers and two wood screws ❷ both of which are
supplied with the electrical box.
– 10 –
❻
❺
❸
❹
❷