Table of Contents
Advertisement
❼
❾
❸
❷
❽
2. Installing the pedal sensor
❶
5) Fit knee lifter pressing rod ❼. Fit hinge ❽ into
the opening in the machine bed, and fit the
C
machine head to table rubber hinge ❷ before
placing the machine head on cushions ❾ on the
four corners.
6) Securely attach head support rod to the table
until it goes no further.
❽
1) Install the pedal sensor to the table with mounting
screws ❶ supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicu-
lar to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
– 4 –
1. Be sure to install the machine head
support rod supplied with the unit.
2. If a pair of scissors or the like is
caught between the control box and
the table, the control box cover can
break. To prevent such an accident, do
not place anything on C section.
3. Be aware that the control box break-
age and/or oil leakage can occur if
operating the sewing machine with the
machine head support rod removed.
Advertisement
Table of Contents
