Installing The Pedal Sensor; How To Install The Needle - JUKI LZ-2280B Instruction Manual

2. Installing the pedal sensor
❶
3. How to install the needle
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
❷
1) Install the pedal sensor to the table with mount-
ing screws ❶ supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicu-
lar to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
1) Turn the handwheel by hand to raise the needle
bar to the highest point.
2) Loosen the needle clamp screw ❷ . Hold the
needle ❶ so that the long groove B on the nee-
A
B
dle is facing exactly toward you.
3) Insert the needle deep into the hole of the needle
bar in the direction of the arrow until it will go no
further.
4) Securely tighten the screw ❷ .
5) Confirm that the long groove B on the needle
faces toward you.
– 4 –