Set-Up; Installation - JUKI DDL-7000A-7 Series Instruction Manual

II. SET-UP

1. Installation

1) Carry the sewing machine while holding the
machine arm with two persons as shown in the
figure.
(Caution) Never hold the handwheel since it rotates.
❸
❶
❶
23.5mm
❷
A
❾
5) Fit knee lifter pressing rod ❻ . Fit hinge ❼ into the opening in the machine bed, and fit the machine head
to table rubber hinge seat ❽ before placing the machine head on cushions ❾ on the four corners.
6) Securely attach head support rod  to the table until it goes no further.
* Be sure to install the machine head support bar supplied with the unit.
7) Draw out cable  of the control box through cable draw-out hole  to route it to the underside of the sew-
ing machine table.
❽
❸
❶
❹
19.5mm
❸
B
❻
❼
2) Place the sewing machine on a horizontal and
plane place when placing it and do not place any
protruding thing such as a screwdriver or the like.
3) Adjust so that the oil pan is supported at the four
corners of the table. Mount rubber hinge seat ❽
on the table and fix it on the table with a nail.
4) Fix two rubber seats ❶ on side A (operator's
side) using nails ❷ as illustrated above. Fix two
cushion seats ❸ on side B (hinged side) using a
rubber-based adhesive. Then place oli pan ❹ on
the fixed seats.



– 2 –
❽
❼