Update Software Procedure - Redline Communications RedMAX SU-IIR User Manual

6.4.3

Update Software Procedure

1. Start a telnet session to the subscriber using the following settings:
Login:
Password:
2. Enter the 'loadImage' command. The subscriber will prompt you to enter
the following information:
Server IP address: [enter address of FTP server]
File Name:
The subscriber performs FTP server authentication with user name 'target'
and password 'secret' (these settings cannot be altered). The image will be
uploaded to the subscriber and saved in the non-volatile memory (flash).
3. The subscriber must be reset to load the new software. Enter the 'reboot'
command to reset the unit. The telnet session will be terminated.
Login: admin
Password:
admin, welcome to the SS CLI. (Version 0.3)
SUO#> loadImage
Server IP Address: [enter ftp server IP address here]
File Name: [enter binary file name here]
Opening FTP connection.....Done
Downloading image
..............................................................................................................
Done
Programming update........Done
Erasing setup partition. Done.
Writing setup partition. Done.
Erasing boot block. Done
Programming boot block. Done
Flash programming complete.
SUO#>reboot
70-00057-01-01-DRAFT
RedMAX
admin
admin
[enter base station binary file name]
Example Download Dialog with Subscriber
Proprietary Redline Communications © 2006
Page 59 of 60
™
Subscriber Modem
User Manual
December 13, 2006