Connecting customer premises Ethernet equipment directly to the 'Data and
Power Out' connector on the outdoor subscriber Power-over-Ethernet power
adapter may damage customer network interface equipment. Customer
equipment including personal computers, routers, etc., must only be connected
to the 'Data In' port on the PoE unit. Only the outdoors Ethernet interface cable
to the outdoor subscriber can be safely connected to the 'Data and Power Out'
connector.
LED
Green
Blink
4.4
Mounting the Outdoor Subscriber
Refer to the RedMAX Installation Guide (P/N: 70-00059) for detailed installation
instructions.
4.4.1
Outdoor Subscriber with Integrated Antenna
The SU-OIA has an integrated flat panel antenna. The vertical mount bracket can
accommodate a flat vertical surface or 2.45 - 11.45 cm (1 - 4 ½ in) OD masts
found on many commercial tower installations.
70-00057-01-01-DRAFT
RedMAX
PoE Power Adapter Caution
Warning to Service Personnel: 48 VDC
Table 7: System - Ethernet Data Port Link/Act LEDs
Port
Connected
Not connected
Figure 20: SU-OIA System Connections Diagram
Proprietary Redline Communications © 2006
™
Subscriber Modem
Output is out of range
Page 28 of 60
User Manual
AC
Power is active
December 13, 2006