5.3.5
installedVer - Installed Version
Use the installed version command to view information about the binary files
saved in the subscriber non-volatile RAM, and to select the active version of
software. See also installedVer, loadImage, and version commands. The
following table lists all commands available in this mode.
Table 15: CLI - installedVer - Installed Version Commands
Command
set
show
70-00057-01-01-DRAFT
RedMAX
Description
Switch the active version of image.
Active - Load the binary file from the selected partition:
0 - Load from partition #0.
1 - Load from partition #1.
Display the current setting for all parameters.
Partition #0:
MajorNumber: Major software release number.
MinorNumber: Minor software release number.
ReleaseNumber: Software release build number.
Designation: Software release designation.
Partition #1:
MajorNumber: Major software release number.
MinorNumber: Minor software release number.
ReleaseNumber: Software release build number.
Designation: Software release designation.
Active: Indicate the active partition.
0: Partition 0 will be loaded at reboot.
1: Partition 0 will be loaded at reboot.
For example:
Partition #0
Partition #1
------------------------ ------------------------ ------------------------
MajorNumber:......1
MajorNumber:......1
MinorNumber:......0
MinorNumber:......0
ReleaseNumber:..100
ReleaseNumber:...98
Designation:......1
Designation:......1
Proprietary Redline Communications © 2006
Page 38 of 60
™
Subscriber Modem
User Manual
Others
Active:...........1
December 13, 2006