3.3
Indoor Subscriber Connections and Controls
All external connectors and controls are located on the bottom of the subscriber
unit. Refer to the following sections for details.
Figure 9: Subscriber System Connections - Power Connector
3.3.1
Ethernet Port
The auto-sensing 10/100Base-T Ethernet port connects through the Ethernet cable
to the customer network equipment. The subscriber exchanges data with the
network through this port (auto-sensing polarity). It is recommended to use a
flexible Ethernet cable.
3.3.2
Reset Switch
The subscriber features a reset switch recessed in the bottom of the subscriber
unit. You may require a narrow pointed item (ex. paper clip) to activate the reset
switch.
70-00057-01-01-DRAFT
RedMAX
Figure 10: Subscriber Ethernet Connector (Under Base)
Figure 11: Subscriber Reset Switch (Under Base)
Proprietary Redline Communications © 2006
™
Subscriber Modem
Page 21 of 60
User Manual
December 13, 2006