Mode Commands; Table 10: Cli - Root Mode Commands - Redline Communications RedMAX SU-IIR User Manual

5.3

Mode Commands

The system defaults to root mode when you login to the subscriber. The following
table lists commands that have their own mode. From each mode, you can directly
display and modify (if applicable) each of the modes parameters. Enter 'exit' or
CTRL-Z to return to root mode. All commands are case-sensitive.
The following table lists mode commands available in the root directory.
Command
boardConfig
bsIdTable
diagStatistics
ethTag
installedVer
ipAddress
loadImage
modThresh
monitor
phyConfig
privacySS
rfConfig
softwareUpgrade
status
set
show
70-00057-01-01-DRAFT
RedMAX

Table 10: CLI - Root Mode Commands

Description
Display/modify the board parameter configuration.
Access the Management Base Station ID table.
Display/modify the Diagnostic Status.
Display/modify the Ethernet Tagging.
Display the installed software version(s).
Display/modify the IP address.
Download and run a new software image.
Display/modify thresholds for adaptive modulation.
Display dynamically updating values for all status table statistics.
Display/modify the PHY configuration.
Display/modify privacy settings.
Display /modify the RF configuration.
Upgrade software and select the active version.
Display the Management Status.
Enter a new values for parameters.
Display current parameter settings.
Proprietary Redline Communications © 2006
Page 32 of 60
™
Subscriber Modem
User Manual
December 13, 2006