5
C
L
I
5
C
L
I
This section describes the subscriber CLI commands.
5.1
Introduction
The subscriber can be configured using a Telnet connection established through
the subscriber Ethernet port or over the wireless interface from the base station.
The CLI can not be used to setup service flows. All service flows will be setup by
the base station.
5.2
CLI Modes
The subscriber CLI interface supports several modes of operation. From root
mode you can display a list of all user modes, reboot the subscriber system, and
logout from the Telnet session. Monitor mode provides a dynamic display of the
current system statistics, updated each few seconds. Configuration modes allow
you to view and adjust the subscriber network and wireless settings.
5.2.1
Telnet Connection
Telnet Login
Type 'telnet' followed by the IP address of the subscriber system, depress ENTER,
and enter the account and password when prompted. The subscriber supports two
separate user accounts:
Account
admin
user2
guest
Telnet Logout
To exit from the Telnet session, you must be in the root directory. Go to the root
directory by typing:
Exit [ENTER] or CTRL-Z (hold down the CTRL key and depress Z)
Exit from a CLI session by typing:
logout [ENTER]
The system prompts for logout confirmation. Depress 'Y' to complete the logout
process.
70-00057-01-01-DRAFT
RedMAX
C
o
m
m
a
n
C
o
m
m
a
n
Table 8: CLI - Command Groups
Password
Description
admin
Full system control
user2
Read-only with some functional restrictions (not allowed to use
the 'set' command).
guest
Same as user2.
Proprietary Redline Communications © 2006
™
Subscriber Modem
d
s
d
s
Page 30 of 60
User Manual
Chapter
5
December 13, 2006