Table of Contents
Advertisement
4.3
Subscriber Connections and Controls
4.3.1
Ethernet Port (and Cable)
The auto-sensing 10/100Base-T Ethernet port connects through the outdoor
Ethernet cable to the indoor PoE Adapter. The subscriber receives DC power and
exchanges data with the indoor network through this port (straight-through
connection). The cable access entrance on the subscriber is equipped with a
weatherproof seal.
Important -- Warranty Information -- Ethernet Cable
The outdoor subscriber factory warranty is valid only if the Redline
supplied outdoor CAT-5 Ethernet cable is installed and properly
weatherproofed according to instructions in this manual.
The outdoor end of the Redline supplied outdoor (hardened) CAT-5 Ethernet
cable is terminated with an environmentally sealed RJ-45 connector for
connection to the subscriber . The minimum diameter to pass this connector
through a conduit or hole is 26 mm (1 in).
The indoor end of the Redline supplied outdoor (hardened) CAT-5 Ethernet cable
is terminated with a standard indoor RJ-45 connector for connection to the indoor
PoE adapter. The minimum diameter to pass this connector through a conduit or
hole is 18 mm (11/16 in).
4.3.2
RF Port
An external RF connector is provided only on the outdoor subscriber with
external antenna (SU-ORF) model. The transceiver RF port (female N-type
connector) is used for sending/receiving the RF signal to/from the antenna. A
short coaxial cable is provided to connect the transceiver to the external antenna.
4.3.3
Grounding Connection
A ground terminal is located on the rear of the subscriber. Use this screw to
terminate the ground wires. Correct grounding is very important for safe operation
of wireless equipment. Ensure that all grounding connections are in accordance
with local and national standards.
70-00057-01-01-DRAFT
RedMAX
Figure 17: Outdoor Ethernet Cable - Cable Connection
Proprietary Redline Communications © 2006
™
Subscriber Modem
Page 26 of 60
User Manual
December 13, 2006
Advertisement
Table of Contents
