5.3.4
ethTag - Ethernet Tagging
Use these commands to identify data traffic through this subscriber by using
802.1Q VLAN tags.
When tagging is enabled, each upstream packet (received on the subscriber
Ethernet port) is tagged with the specified VID. If the packet already has a VID
tag, a new outermost tag is added (Q in Q). The packet is then forwarded to the
wireless interface.
When tagging is enabled, each downstream packet (received on the subscriber
wireless interface) is checked for the specified VID and matching tags are
removed. If there are multiple VID tags (Q in Q), only the outermost tag is
checked/removed. The packet is then forwarded to the Ethernet port.
The following table lists all commands available in this mode.
Command
reset
set
show
Note: The base station passes all ingress and egress traffic without modification.
70-00057-01-01-DRAFT
RedMAX
Table 14: CLI - ethTag - Ethernet Tagging Commands
Description
Set all parameters to factory default values.
Change parameter settings.
Active: Status of the VLAN Tagging feature:
0: Inactive - will not check or add/delete VLAN tags.
1: Active - will actively add VLAN tags to upstream traffic and remove
matching VLAN tags from downstream traffic.
Value: Enter the VLAN ID to be added/removed from data traffic.
Priority: Enter the priority assigned to each VLAN tagged packet sent
over the wireless interface to the sector controller.
Display the current setting for all parameters. For example:
Structure --- <<SS Ethernet Tagging Data>>
Active:.............inactive(0)
Priority:...........0
Value:..............0
Proprietary Redline Communications © 2006
™
Subscriber Modem
Page 37 of 60
User Manual
December 13, 2006