3.2
LED Indicators
The subscriber features LED indicators to assist with installation and
troubleshooting of the wireless interface and the Ethernet interface.
3.2.1
WiMAX / WAN Signal
The subscriber features five LEDs to indicate signal strength. If no signal or a
weak signal is detected, only the left LED (-) will be lit. As signal strength
increases, more LEDs will be lit. A strong signal is indicated by all LEDs being
lit.
Phase
1
2
3
4
Table 4: System - Indoor CPE WAN LEDs - Signal Strength
3.2.2
LAN System
The LAN LEDs indicate connectivity and activity on the Ethernet port. Refer to
the following table for details.
Left LED
Right LED
70-00057-01-01-DRAFT
RedMAX
Figure 8: Subscriber LED Display
Table 3: System - Indoor CPE WAN LEDs
Activity
Description
Power-on /
All LEDs are on for a short period.
Reset
Frequency
Walking LED on (left to right to left).
Scanning
Network
The number of LEDs blinking represent the received
Entry
signal strength. Value is from zero (all LEDs off) to
five (all LEDs on). See table following.
Subscriber
The number of LEDs on represent the received signal
is
strength. Value is from zero (all LEDs off) to five (all
Registered
LEDs on). See table following.
LED Indicators Lit
5
4
3
2
Table 5: System - LAN LEDs
LED is on when the Ethernet port connection is active.
LED blinks when there is Ethernet data traffic.
Proprietary Redline Communications © 2006
™
Subscriber Modem
Signal Strength (RSSI)
< -45
-45 to -58.9
-58 to -75.3
-75 to -86.5
Page 20 of 60
User Manual
December 13, 2006