5.3.13 set - Set Commands
The set mode can be used to directly modify all available subscriber parameters.
The parameters listed in this table do not have a separate mode, and can openly be
modified by the set command.
Enter a new value for one or more fields in mode.
set [Enter]
Modify selected field(s).
set [mode] [field] [value] [value] [field] [...] <ENTER>
Command
dhcpRelayAgent
ethernet
managedSS
sysContact
sysLocation
sysName
70-00057-01-01-DRAFT
RedMAX
Display all fields.
Table 22: CLI - set - Modify Subscriber Parameters
Description
Use this setting to enable or disable the DHCP relay setting.
0 -- Disable DHCP relay agent.
1 -- Enable DHCP relay agent.
Use this setting to modify the Ethernet port auto negotiation, link
speed, and duplex settings.
AutoNegEnabled <value>
0 -- Disabled
1 -- Enabled.
LinkSpeed <value>
0 -- 10M
1 -- 100M.
LinkDuplex <value>
0 -- Half
1 -- Full.
The managedSS command allows you to configure the subscriber
for independent operation, or enable management using the
RedMAX EMS system. The managedSS parameter is controlled
from root mode. The following table lists all commands available
for managedSS.
0 - Disable remote management.
1 - Enable remote management.
Enter device administration contact information (255 chars max.).
Enter the device location (255 characters max.).
Enter the device name (255 characters max.).
Proprietary Redline Communications © 2006
Page 46 of 60
™
Subscriber Modem
User Manual
December 13, 2006