5.3.1
boardConfig - Board Setup Commands
The boardConfig mode allows you to view and modify the subscriber board level
settings. The following table lists all commands available in this mode.
Command
reset
set
show
70-00057-01-01-DRAFT
RedMAX
Table 11: CLI - boardConfig - Board Commands
Description
Set all parameters to factory default values. Confirmation required.
Change parameter settings.
RefOscFreq: Enter an unsigned integer as the new RefOscFreq value
(Hz). Value can be only 32000000 or 40000000.
TxIfFreq: Enter the TxIfFreq (Hz) value (around 44000000).
RxIfFreq: Enter the RxIfFreq (Hz) value (around 44000000).
RfType: Enter an unsigned char as the new RfType value. One of:
0 - None
1 - Radia 3.5 GHz
2 - Radia 5.8 GHz
3 - SMI
4 - Factory Test
IfPresent: Enter an unsigned char as the new IfPresent value.
0 - Baseband only
1 - IF present
TxSpectrumInv: Enter a boolean as the new TxSpectrumInv value.
RxSpectrumInv: Enter a boolean as the new RxSpectrumInv value.
Buzzer: Antenna positioning buzzer.
0 - Disabled
1 - Enabled.
DebugLog: Factory debug messages.
0 - Disabled.
1- Enabled.
Display the current setting for all parameters. For example:
Structure --- <<SS Mmgt Board Configuration Parameter>>
Transmit
Receive
------------------------------
------------------------------
IfFreq:
44000000Hz
IfFreq:
SpectrumInv: disabled(0)
SpectrumInv: disabled(0)
Proprietary Redline Communications © 2006
Page 33 of 60
™
Subscriber Modem
User Manual
Others
----------------
44000000Hz
RefOscFreq:
RfType:
IfPresent:
Buzzer:
DebugLog:
32000000Hz
SMI(3)
IF_Present(1)
disabled(0)
disabled(0)
December 13, 2006