Attaching The Hopper Assembly; Attaching The Discharge Chute; Attaching The Hitch Plate - DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual

Hopper
Assembly
Figure 7
Figure 8
Hardware
Tongue
Assembly
Figure 9
16.50 PRO DR
®
16 RAPID-FEED™ CHIPPER

Attaching the Hopper Assembly

NOTE: We recommend that you have someone help you lift the
Hopper
Hopper in place and support it until it is secured to the Chipper.
Hardware
Tools Needed:
NOTE: Install hardware with Bolt Head on the top side.

Attaching the Discharge Chute

Tools Needed:
Discharge
Chute
Bolts and
Locknuts

Attaching the Hitch Plate

Tools Needed:
Hitch
Plate
•
Two 1/2" Wrenches
1. Attach the Hopper Assembly to the Chipper with six
5/16"-18 x 1" Bolts, twelve Flat Washers (one Washer
on Bolt side and one on Lock Nut side) and six Nylon
Lock Nuts (Figure 7).
•
Two 1/2" Wrenches
1. Position the Discharge Chute as shown and secure
with two 5/16-18 x 5-1/4" Bolts and Nylon Locknuts
(Figure 8).
•
Two 1/2" Wrenches
1. Position the Hitch Plate onto the Tongue Assembly as
shown and secure with two 5/16-18 x 1" Bolts and
Nylon Locknuts (Figure 9).