DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual page 59

3. Remove the Coll ar from the axle by loosening the Set
Screw with a 5/32" allen wrench and pulling the Collar
off.
4. Remove the Wheel and Spacer that is behind the
Collar from the Axle.
5. Pull the opposite wheel along with
Chipper.
6. Slide the Spacer, Wheel and Collar back onto the Axle
and store in a safe place.
7. Remove the four Bolts, Lock Washers and Nuts (two
l arg washers on top two hole e
the chipper Frame with two 9 16" wrenches (Figure
5 7).
8. P osi on the Fender and reinstall the four Bolts, Lock ti
Washers and Nuts (two large washers on top two
holes o nly to the side of the chipper Fram )
58).
9. Repeat th Fender installation for the opposite side. e
10. Position the new Axle Assembly under the Chippe
and secure it to the Axle Brackets w
Locknuts and Washers (on the side with slots) and
two Bolts and Locknuts (on side with holes) us
9/16" wrenches (Figure 59).
the Axle from the
s on ly) from the side of
/
ith two Bolts,
CONTACT US AT www.DRpower.com
Bolt, Nut, Lock
Washer and Flat
Washer (top two
holes)
Bolt, Nut and
Lock Washer
(bottom two
holes)
Figure 57
e (Figure
Bolt, Nut, Lock
Washer and Flat
Washer (top two
holes)
Figure 58
r
Mounting
Slots this
side
ing two
Figure 59
or CALL TOLL FREE 1-800-DR-OWNER
Bolt, Nut and
Lock Washer
(bottom two
holes)
Axle Bracket
Axle
Axle
Assembly
Assembly
Hardware
Fender
55