DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual page 62

Figure 66
Wire Harness
Cable
Ties
Figure 67
Ground
Wire
Trailer
Hitch Bolt
Figure 68
16.50 PRO DR
®
58 RAPID-FEED™ CHIPPER
7. Attach both Light Brackets to the Frame with Bolts a
Light
Bracket
Bolt and
Locknut
8. Secure the Wires under the Frame with Cable Ties at
9. Pull the excess wire to the front of the Chipper.
10. Strip 1" of insulation from the end of the White
11.
Cab le Tie
Excess Wire
to Tow B ar
12. Roll up the extra wire and wire tie it to the Tow Bar.
NOTE: We recommend that you wrap the Harness Wires together
with e lectrical tape about every twelve inches starting at the W
Harness Connector end and going back to where the wires go to
either side of the Frame.
Locknuts with two 1/2" wrenches (Figure 66).
the four places shown (Figure 67).
(Ground) Wire.
Loosen a Trailer Hitch Bolt, wrap the White (Ground )
Wire around the Bolt, and then re-tighten with two
3/4" wrenches (Figure 68).
nd
ire