Removing And Replacing The Engine Oil; Removing, Replacing And Adjusting The Drive Belt - DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual

Removing and R eplacing the Engine Oil
SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.
Tools and Supplies Needed
•
SAE 30 HD Oil
•
Oil Filter Wrench
•
5/8" Wrench
•
Suitable container for used oil
•
Rags
NOTE: Drain the oil when the engine is warm. Warm l
drains quicker and more completely.
1. Position a suitable oil receptacle under the en
Drain Plug and remove the engine oil Fill Cap.
2. Remove the Oil Drain Plug from the Oil Drain
with a 5/8" wrench (Figure 25). Allow the used oil to
drain completely, and then replace the Oil Drain Plug.
3. Replace the engine oil using SAE 30 HD oil (see
"Adding Engine Oil and Gasoline" in Chapter 3 for
instructions on adding oil).
4. Reattach the spark plug wire.
NOTE: Be sure to use environmentally safe disposal
procedures in the disposing of the used oil.

Removing, Replacing and Adjusting the Drive Belt

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK P LUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.
USE ONLY DR BELTS ON YOUR MACHINE. THE BELTS HAVE BEEN THOROUGHLY TESTED AND
PROVEN FOR MANY HOURS OF USE.
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER
oi
Dipstick
gine oil
Elbow
Figure 25
Oil Drain
Elbow
and Plug
31