DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual page 61

Installing the Tail Lights:
1. Push the Yellow/Brown and Green/Brown Wires of
the Wire Harness through the hole in the front left
side of the Frame (Figure 63).
2. Pull the Wires to the back of the Chipper Frame. Pu
the Yellow/Brown Wires up through the Wire Hole on
the le ft rear of the Frame (Figure 64). Do not pull the
Wires through the Bracket Holes.
3. Pull the Green/Brown Wire up through the Wire Hole
in the right rear of the Frame.
4. Strip 1/2" of insulation from the ends of the
Yellow/Brown wires and Green/Brown wires and twist
the individual wire ends to aid in installation.
NOTE: Ensure that you have the correct Light for each side.
The Side Light of each Light Assembly must face to
the outside of the Chipper.
5. Push the Yellow Wire into the top left hole in the back
of the light socket and push the Brown Wire into the
top right hole (Figure 65).
NO TE: The wires will be connected and retained in the li
socket holes by spring-loaded connections.
6. Push the Green Wire into the top right hole in the
back of the light socket and p
the top left hole.
ush the Brown Wire into
CONTACT US AT www.DRpower.com
Figur e 63
ll
Left Side
of Frame
Wire
Hole
Figure 64
ght
Figure 65
or CALL TOLL FREE 1-800-DR-OWNER
Hole in
Frame
Wire
Harness
Rear of
Frame
Light
Bracket
Holes
Yellow
Wire
Brown
Wire
Side
Light
57