10.2 Replacing The Filter - Burkert AirLINE 8652 Quick Start Manual

Fastening screws, electronic module
Fastening screw, valve
Fig. 23: Replacing a valve without minimum distance to the front edge
of the control cabinet
→
Pay attention to the safety instructions.
→ Use a screwdriver to undo the fastening screws of the elec-
tronic module and the valve.
→ Remove the electronic module from the top.
→ Remove the valve upward from the valve island.
→ Insert a new valve into the valve slot.
→ Place the electronic module back on the valve island.
→ Tighten the fastening screws of the electronic module and the
valve (tightening torque 2 Nm).
30
english
Type 8652
Maintenance, troubleshooting

10.2 Replacing the filter

Danger
risk of injury from high pressure and discharge of medium.
▶ Before working on the device or system, secure the actuators
against moving.
▶ Before working on the device or system, switch off the pres-
sure. Vent or drain lines.
Screw
Fig. 24: Replacing the filter
→ Observe safety instructions.
→ Loosen the screw, extract the connection module from the front.
→ Use a flat-blade screwdriver to extract the filter.
→ Insert a new filter. Make sure to insert the pins of the filter into
the intended holes.
→ Slide in the connection module and screw tight (tightening
torque 2 Nm).
Pins
Filter (for filtering the
auxiliary pilot air)