Assembly On The Base Of The Control Cabinet Or The Wall Of The Control Cabinet With Airline Quick - Burkert AirLINE 8652 Quick Start Manual

6.2 Assembly on the base of the control
cabinet or the wall of the control
cabinet with AirLINE Quick
For assembly, initially prepare a cut-out on the base or the wall of
the control cabinet and drill the holes for the fastening screws. The
cut-out can be created, e.g., through laser-cutting or punching (see
"Tab. 3", page 15).
noTe
The cut-out at the control cabinet must be free from burr to
ensure the seal between AirLINE Quick and the control cabinet
is not damaged.
note when measuring the cut-out:
To be able to utilize the Hot Swap function (easy valve
replacement during operation), always observe a minimum
distance to the front edge of the control cabinet when installing
the valve island in the control cabinet (see "Fig. 6"). The valves
can only be extracted from the front of the valve island when
the minimum distance has been observed.
The minimum distances [mm] to the left, right, front, and top
depend on the position of the valve island in the control cabinet:
position in the control cabinet
base of the control cabinet
right-hand wall
left-hand wall
Tab. 1: Minimum distances by assembling with AirLINE Quick
14
A-A (1 : 2)
60.5 30 50 50
60.5 50 – 50
60.5 – 50 30
english
Mounting plate
Z
Fig. 6: Assembly in the control cabinet with AirLINE Quick
→ Make sure the seal between AirLINE Quick and the control
cabinet is undamaged.
→ Place the valve terminal in the control cabinet on the pre-
pared cut-out.
→ Fix from the outside using M5x10 screws (tightening torque
2.5 Nm).
Valve type
2x3/2-way
– Position of valve outputs
5/2-way
30
5/3-way
50
Tab. 2: Assignment of the pneumatic connections for AirLINE Quick
Type 8652
Assembly
min. 60,5
max. 19,5 min. 73
Distance from the control cabinet
rear wall to the mounting plate
pneumatic connection
Valve output airline Quick
2x3/2 + 5/2 + 5/3 way
2
4
Position of valve outputs
2x3/2 + 5/2 + 5/3 way
2
4