Electrical Connection Gateway - Burkert AirLINE 8652 Quick Start Manual

CauTIon
risk of injury due to discharge of medium and malfunctioning.
Medium may escape if the seals are not seated correctly. The
function of the device may be restricted by pressure losses.
▶ Ensure that all the seals are seated correctly.
risk of injury from damaged contacts.
Damaged contacts may result in a short circuit and
malfunctioning.
▶ Do not bend contacts.
▶ If contacts are damaged or bent, replace the affected
components.
▶ Do not switch on the device unless the components are in
perfect condition.
7.1

Electrical connection gateway

Further information on cabling BüS networks can be
found under the following link:
Guideline for cabling büS networks
noTe
To ensure electromagnetic compatibility:
▶ Only use shielded cables.
▶ Ground the standard rail with low impedance to guarantee
the best possible EMC protection.
▶ With AirLINE Quick, connect the control cabinet housing to
the functional earth (FE) to connect the cable shielding to
ground.
Type 8652
Installation
Possible cable cross-section: ≤1.5 mm
→ Connect the spring-type terminal according to the configuration
(see "Tab. 4")
→ Establish Ethernet or PROFIBUS DPV1 connection according
to the assignment (see "Tab. 5" and "Tab. 6").
→ Apply supply voltage.
Configuration of 5-pin spring-type terminal
connector view Terminal
Red
White
Green
Blue
Black
Tab. 4: Configuration of 5-pin spring-type terminal
In the case of Industrial Ethernet and Profibus DPV1 the terminals are
2)
assigned only when using several Bürkert devices (EDIP) or in combi-
nation with the Communicator.
english
2
description
Supply voltage 24 V
2
CAN H (büS connection)
Shielding
2
CAN L (büS connection)
GND
17