To The Operator - Taylor PH61 Operator's Manual

Section 2
The unit you have purchased has been carefully
engineered and manufactured to give you
dependable operation. When properly operated and
cared for, it will produce a consistent quality product.
Like all mechanical products, this machine will
require cleaning and maintenance. A minimum
amount of care and attention is necessary if the
operating procedures outlined in this manual are
followed closely.
This Operator's Manual should be read
before operating or performing any maintenance on
your equipment.
The Model PH61 will NOT eventually compensate
and correct for any errors during the set-up or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly
recommended that personnel responsible for the
equipment's operation, both assembly and
disassembly, study these procedures in order to be
properly trained.
When your machine is delivered or if it has been in
the OFF position for more than 24 hours,
disassemble the unit following procedures found on
page 44. Follow assembly procedures on page 25
to re-assemble your machine.
Dairy products are susceptible to
bacterial contamination due to improper product
handling. Therefore, be sure to use clean
sanitary conditions when handling mix.
The machine must be disassembled, cleaned,
sanitized, and lubricated every two weeks.
ALWAYS FOLLOW LOCAL HEALTH CODES.
In the event you should require technical assistance,
please contact your local authorized Taylor
Distributor.
131212

To the Operator

To the Operator
Note: Your Taylor warranty is valid only if the parts
are authorized Taylor parts, purchased from the
local authorized Taylor Distributor, and only if all
required service work is provided by an authorized
Taylor service technician. Taylor reserves the right
to deny warranty claims on units or parts if
non-Taylor approved parts or incorrect refrigerant
were installed in the unit, system modifications were
performed beyond factory recommendations, or it is
determined that the failure was caused by abuse,
misuse, neglect, or failure to follow all operating
instructions. For full details of your Taylor Warranty,
please see the Limited Warranty section in this
manual.
During the heat treatment process, the product is
brought to a temperature sufficient to destroy
bacteria and is returned to a standby temperature.
The special control system will insure that the
product is heated and maintained at the set
temperature for the full 30 minutes. This time is
required to insure that bacteria is destroyed. If the
unit was unable to complete the heating cycle, the
LCD will read:
"HEAT TREAT CYCLE FAILURE - FREEZER
LOCKED - PRESS SEL KEY". If this is the case, or
if you require technical assistance, please contact
your local authorized Taylor Distributor.
If the crossed out wheeled bin symbol is
affixed to this unit, it signifies that this unit is
compliant with the EU Directives as well as other
similar end of life legislation in effect after August
13, 2005. Therefore, it must be collected separately
after its use is completed, and cannot be disposed
as unsorted municipal waste.
The user is responsible for returning the unit to the
appropriate collection facility, as specified by your
local code.
For additional information regarding applicable local
disposal laws, please contact the municipal waste
facility and/or local authorized Taylor distributor.
4
PH61 Peristaltic Pump