Language Selection; Factory Default Settings - Hydronix Hydro-View HV02 User Manual

Since there are only two physical inputs available on the Hydro-View, it is not possible to
use all of these facilities on a single installation. However, it is most unlikely to need any
more than two facilities on the same system and so there is not usually a problem.
Setting both inputs to perform the same function will lead to unspecified results
and must be avoided.

Language selection

The Hydro-View now supports operation in many common languages with additional
support being added as required.
To select the operating language, choose Language from the main menu and simply
select from the list of available languages shown.

Factory default settings

Prior to shipment by Hydronix, the Hydro-View operating parameters will have been set to
default values. Since these are quite numerous it is useful to be able to reset them all to a
known state, particularly when first commissioning a system.
Selecting Factory defaults from the main menu produces a display referring the reader to
this manual. This is to avoid unintentional resetting of the values.
To restore the factory defaults, press the centre and right-hand function keys
simultaneously. A confirmation pop-up box will appear which you must accept before the
default values are restored.
The current default values are tabulated in the following pages. Use the right hand column
in each section to record the values you have used in your system. A copy of these tables
will also be helpful should you need to call Hydronix for technical support.
ADVANCED USER OPTIONS AND CONFIGURATION
HYDRO-VIEW USER GUIDE D0022 REV 1.06
37