Set Plant Type - Danfoss ADAP-KOOL AK-HP 780 Design Manual

Configuration - continued

Set plant type

1. Go to Configuration menu
2. Select plant type
Press the line Select plant type.
3. Set plant type
4. Set Common functions
AK-HP 780 Heat pump controller RS8GF202 © Danfoss 2015-08
When the installation type is to be configured, it can be done in two
ways:
Either
Quick setup
Or
All settings can be entered on the following pages.
In the example, we select this set-up mode to get through the descrip-
tions of the functions.
Further settings:
External main switch to Yes
Use Alarm output to High. (At "High" the relay is only activated for
high-priority alarms).
Here you can make a choice
between a number of prede-
fined combinations, which at
the same time determine the
connection points.
At the end of the manual there
is an overview of the options
and connection points.
After configuration of this
function, the controller will shut
down and restart. After the re-
start, a large number of settings
will have been made. These
include the connection points.
Continue with the settings and
check the values.
If you change some of the set-
tings, the new values will come
into force.
49