Mounting; Mounting Of Analog Output Module - Danfoss ADAP-KOOL AK-PC 783 Design Manual

Mounting

Mounting of analog output module

1. Lift the top part off the basic module
The basic module must not be connected to voltage.
Press in the plate on the left-hand side of the light-emitting
diodes and the plate on the right-hand side for the red address
changers.
Lift the top part off the basic module.
2. Mount the extension module in the basic module
3. Put the top part back on the basic module
46 Capacity controller RS8GN202 © Danfoss 11-2013
The analogue extension module used for mounting inside the control
module is shown for guidance only. This is not used in the example.
There are two outputs.
AK-PC 783