Extron electronics eBUS Button Panel Decorator-Style Series Setup Manual page 13

Mounting with a UL Listed Electrical Junction Box
Install the junction box by following the instructions provided by the manufacturer.
1.
Use the two provided Phillips head screws to secure the module to the junction box (
2.
Use the two screws provided to secure the frame to the module (
3.
Electrical
Junction
Box
Mounting with a UL Listed Electrical Junction Box
Figure 14.
Removing Decorator-Style EBPs
If you need to remove a decorator-style EBP from where it has been mounted, follow these steps:
Remove the two screws holding the frame to the module (see figure 13,
1.
Remove the two screws holding the module to the junction box or wall mounting bracket (
2.
Remove the unit from the wall (
3.
Electrical
Junction
Box
Removing the EBP 106 D
Figure 15.
3 3
Frame
3 ) and remove the eBUS cables from the rear panel connectors.
2 2
3 3
Frame
4 ).
4 4
1
).
1 1
Product Category
3 ).
2 ).
13