Panel Programming - EMS FireCell Programming Manual

Panel Programming

The Radio Hub, RCCs and all wireless devices must now be added to the control panel. Ensure the Loop
number and addresses programmed at the Radio Hub correspond to that programmed at the Control
Panel.
Ensure write switch is set to enable.
Turn the key switch to the enabled position.
2
Press the
3
Press the
Press the 2
Now to enter the pin number, press the
Press the 'Enter' button to enter the pin.
Enter the 'Edit Con g' menu with the
3
Press the
Press the
2
Press the
1
Press the
2
Press the 1
Press the
2
1
Press the
is shown.
Press the 'Enter' Button to enter. Con rmation of the addition to the system should now be
shown.
Once complete, press the 'Exit' button to escape the menu.
©2019 EMS Ltd. All rights reserved.
button to enter the menu.
button to scroll down the menu until 'Access Level 3' is highlighted.
button to enter the menu.
button to scroll down the menu until 'Add device' is highlighted.
button to enter the menu.
3
& buttons to highlight the desired loop number for the device.
button to select the loop required.
3
& buttons to scroll through the available address numbers.
button to select the address required.
3
& buttons to scroll through the device types until the desired device type
3
button four times (thus entering 3333).
2
button.
Page 10 of 40 MK98 Iss17 05/04/2019 AJM