Start Fast Test; Rcc Comms Path; Chg Rcc Comms Path; Replace Rcc - EMS FireCell Programming Manual

Start Fast Test; in this menu, loops can be entered into fast test for ease of testing. This allows the
detectors on the selected loops to be triggered into an alarm condition quicker than normal. The led on
the device will ash to indicate it is in this fast test mode. A time period of between 1 and 30 minutes is
selectable which decrements and is then re-generated on a re alarm event. The devices automatically
come out of fast test mode when the timer expires or the fast test mode is exited.
Advanced
Front Display
RCC Comms Path; this menu allows you to view to path of communication between Radio Cluster
Communicator (RCC) to the Radio Hub whether it is direct from the RCC to the Radio Hub or from the
RCC to the Radio hub via another RCC. The loop number and address number is shown along with the
number of hops the RCC uses to communicate to the Hub. Pressing the rotary control with the required
RCC shown will then show the RCC or Hub that particular RCC is communicating to.
Advanced
Front Display
Chg RCC Comms Path; this menu allows you to change to path of communication between Radio
Cluster Communicator (RCC) to the Radio Hub whether it is direct from the RCC to the Radio Hub or from
the RCC to the Radio Hub via an RCC.
Advanced
Front Display
Replace RCC; this menu option is not currently used on this version of software.
Sounder Mode; this menu allows the auto silencing of wireless sounders to be programmed. Available
options are Continuous which disables any auto silencing rules and 30 min cut o . The default setting is
to 30 min cut o which will turn all wireless sounders o after 30 minutes to conserve battery life. Any
subsequent re alarm activations will re-activate the sounders again.
Advanced
Front Display
©2019 EMS Ltd. All rights reserved.

Start Fast Test

RCC Comms Path

Chg RCC Comms Path

Sounder Mode

Page 34 of 40 MK98 Iss17 05/04/2019 AJM