Electronics – Spo2 - GE PANDA Service Manual

Possible Causes
4.4.9 Electronics – SpO
4.4.9.1 No SpO
Possible Causes
Improper mating of
probe with probe
connector
Dislodged SpO
connector
Reverse probe
connection
Defective SpO
Circuit
4.4.9.2 No SpO
Possible Causes
No comm. between
the SpO I/F PCA
2
and Control PCA
Service Manual
Step Troubleshooting Procedure
Disconnect scale harness at the Probe Panel
3. Interface Board. Plug in replacement cable and
re-test. Replace harness as necessary.
Check the Probe Panel Interface Board connection
at the Control PCA (J2). If OK, then there is either a
4.
problem with the Probe Panel Interface Board or
Control PCA.
Replace the Probe Panel Interface Board or Control
5.
PCA as necessary.
2
Probe Detected
2
Step Troubleshooting Procedure
Possible cause if SpO
1.
appear when plugged in during power ON.
Check that the probe connector at the probe panel
2
2.
(jack plate) is seated properly.
If the blue SpO
from the probe plate, remove the bottom cover
3.
probe panel and snap the connector back into the
connector plate.
Check that the instrument cable and contacts with
4. the SpO
2
correctly inserted and are properly seated.
Flex Remove the bottom cover and verify that the Spo
2
5.
Flex Circuit is properly seated and connected.
Make sure the LED light is lit on the SpO
6.
If not, replace the probe.
Option on Screen
2
Step Troubleshooting Procedure
Check the rail harness connection J40 from the
Probe Panel Interface Board to the SpO
1.
Make sure harness is properly seated and correctly
connected.
Verify the connection from the Control PCA to the
2. Probe Panel Interface Board. Make sure the harness
is properly seated and the connections are correct.
icon doesn't automatically
2
connector has been dislodged
2
disposable patient attachment probe are
Chapter 4: Troubleshooting
Troubleshooting Tables
Comments
Scale harness
part #:
6600-1586-700
Comments
3 mm Hex Wrench
Rail harness part #:
2
6600-1587-700
probe.
2
Comments
SpO Rail
2
I/F PCA.
2
Harness part #:
6600-1587-700
Part #: 2065772-
001
4-39