Appendix E: Installing Wall Mount Units - GE PANDA Service Manual

Appendix E: Installing Wall Mount Units

To adequately install the Wall Mount Warmer, pre-planning at the architectural design phase is required.
The following instructions describe the manufacturer's recommended method of installation in new
construction. Use only the GE Healthcare hardware provided to mount the Wall Mount Warmer model. The
installation should be approved by the appropriate authorities. Deviation from these recommendations or
attempts to retrofit existing construction should only be undertaken by professionals experienced in
structural design, who in turn are wholly responsible for the structural integrity of the mounting method
they devise.
Note: Mounting the wall mount bracket and the bumper on the wall is not the responsibility of
GE Healthcare service personnel. The hospital or the medical facility shall arrange for the
completion of bracket and bumper mounting task. The GE Healthcare service personnel are
responsible for installing the heater head only after the bracket is securely mounted on the wall at
the specified distance from the floor.
The Wall Mount Warmer installation includes 5 major tasks:
• Installation of the wall mount bracket on the wall -> To be done by the hospital
• Installation of the bumper on the wall -> To be done by the hospital
• Installation of the heater head -> To be done by authorized service personnel
• Heater alignment -> To be done by authorized service personnel
• Installation of mattress height label -> To be done by authorized service personnel
E-1